![]() ![]() Because of the variety of drums on the market, experimentation with your particular set-up at different gage readings and tuning levels is recommended.ĭue to the sensitive nature of the gage, when not in use, keep the DrumDial in its case and keep tension off the tuning tip for prolonged periods of time as this may damage the tuner’s internal mechanism. Ordinarily most drums will be tuned to about 75 for the top head and 74 for the bottom resonant head (snare drums tighter, top 85, bottom 82 and bass drums a little looser at 70 to 72). This is not necessary when tightening a tuning lug. When loosening a tuning lug, be sure to pick the dial up and place it down again to relieve pressure on the head, this will assure a correct gage reading. ![]() Learn more ONLINE STORE Visit the DrumDial online store to purchase tuners and other tuning accessories. This should not be a problem unless the drum head is extremely worn. Featured Artist It's hard to find someone with as much energy & passion as Rich Redmond. However, used heads with indentations and scuffed areas around the edges will make the tuner have different readings if the tuning tip is placed directly on a scuffed surface or in a dent. Picking up the tuner and placing it down again in the same spot should give you an identical gage reading. Now, if you want a different tone, slowly tighten or loosen each tuning lug to your desired tuning point, again matching all gage readings. (Tighten each tuning lug a little at a time, otherwise the drum head will not seat properly.)Ģ. Continue picking up and moving the DrumDial to each tuning point, tightening each tuning lug to achieve identical gage readings. Do this until the drum head is sufficiently tight and the head is properly seated.ģ. At this point, the drum should be in tune with itself. Find the lug with the highest reading and tune the other lugs to match this one. Pick the tuner up and move it to the next tuning lug, and so on (be sure to compress the tuning tip slowly). Take readings using the large needle hand only, the small needle is not used for tuning. At this point, remove your hand from the DrumDial (don’t rest your hand on the drum head as this may give an inaccurate reading). Simply clip it onto the neck of the DrumDial and position the tuner so the Edge Gage lightly touches the inside rim of the drum. This distance can be easily measured using the DrumDial Edge Gage. The DrumDial base should be about ¾ of an inch from the edge of the drum directly in front of a tuning lug. Place the tuning tip on the drum head, always compressing it slowly, until the full weight of the tuner is on the drum. The top cap screw is not used for calibration and should be kept tight and never removed.Position the tuner so the dial is easy to read. 1. Make sure that the tuning tip is finger tight. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |